Alarm Systems

Showing 1-9 of 9 item(s)

LightSYS Plus 4G Module + Antenna - EU

LightSYS Plus 4G Module + Antenna - EU

Support: LightSYS+ - Version 1.1.0.1 GSM 4G Antenna + 3m cable Current Consumption: 30 mA 130 mA max. Operating temperature: -10 C to 55 C Storage temperature: -20 C to 60 C

Part No:CP208-2

Prosys Plus Bus Zone Expander

LightSys Plus Bus Zone Expander

Compatible with LightSYS and ProSYS Max 5 CP179 expanders to LightSYS Max 32 CP179 expanders to ProSYS Plus 8 Wired zone input 4-Wire Bus connection Switched auxiliary power output 22 Programmable zone types Programmable loop response for each zone Zone termination N/C N/O end-of-line resistor and double end-of Switched auxiliary power output

Part No:CP178-1

LightSYS2 and ProSYS Plus 4 Relay Output Module 3A

LightSYS2 & ProSYS Plus 4 Relay Output Module 3A

Compatible with LightSYS and ProSYS Plus 4 High-current form C relays 3Amp Programmable as N/C N/O latched or pulsed Pulse duration is programmable from 1 to 99 seconds Activates as a result of events related to the system partition zone

Part No:CP172-1

ProSYS Plus and LightSYS IP Multi-Socket Plug-in Module

ProSYS Plus and LightSYS IP Multi-Socket Plug-in Module

Multi-Socket IP-Module Plug-in IP Module enables communication over a TCP/IP network Used as primary communication or back up to GSM/GPRS/3G or PSTN commun Enables remote programming of the panel Common monitoring format protocols: SIA Contact ID Simultaneous communication to RISCO Cloud control room FM and Config Cloud redundancy when used with 2G or 3G modules Used for end users application sending email alerts and system status Average power consumption: 55mA Peak power consumption: 105mA Multiple control room environment

Part No:CP184

PSTN Module for LightSYS Plus

PSTN Module for LightSYS Plus

Compatibility: LightSYS Plus Degree: 2 or 3 Allows you to set up communication to an alarm centre

Part No:CP207-1

LightSYS2 and ProSYS Plus 8 Zone Expander

Risco - LightSYS Plus 8 Zone Bus Expander

8 Zone Expander module enables the expansion of the number of wired zo Up to 3 expanders can be added to LightSYS 2 up to 5 expanders 8 Wired Zone inputs 4-Wire Bus connection Switched AUX power output for the use of Smoke Detectors 22 Programmable zone types Programmable zone loop response for each zone Zone termination- N/C N/O End-of-line and Double end-of-line

Part No:CP179

Risco Camera 2MP VU Point WiFi Bullet

Risco Camera 2MP VU Point WiFi Bullet

Sensor: 1/2.7 2 megapixel CMOS Infrared capability: Distance of 30 meters Focal length: 2.8mm wide angle Backlight management: WDR 120 dB Firmware update via camera web interface SD card slot IP67 12VDC 4.8W

Part No:CC253-6

Robo Guard Universal 1 Channel Pulsed Receiver

RoboGuard Universal 1 Channel Pulsed Receiver

A Data receiver for Roboguard transmitters Facilitates data connection to the keypad or the universal transmitte Learns any roboguard signal tamper intruder autotest and remote Tx 12VDC Power input data output and N/C triger terminals Dip switch setting for output polarity and trigger timing

Part No:BD308

Wireless 2-Way Repeater 868/869MHz

Wireless 2-Way Repeater 868/869MHz

High sensitivity superheterodyne receiver and transmitter Up to 12 unidirectional transmitters per receiver Possibility to put up to 7 repeaters Internal backup batteries (not supplied) Power supply 12-16 volts AC or DC Frequency 868 MHz

Part No:CP187-3